> Lighting Control > Room temperature > MTN645129,Heating actuator REG-K/6x230/0.05 A 
For actuation of thermoelectric valve drives for heating or cooling ceilings. The heating actuator has 6 electronic outputs. Up to 4 valve drives can be connected to each output. The outputs are either switch activated (1 bit) or PWM signal (1 byte) activated. Each output is overload-protected and short-circuit-protected. For installation on DIN rails EN 50022.
The bus is connected using a bus connecting terminal; a data rail is not necessary.
KNX software functions: Cycle time, status feedback, summer and winter operation, cyclical monitoring of variables, locking each output in a forced position, behaviour on bus power failure and recovery, overload and short circuit status, mains power loss reporting, collective fault reporting connected to all valves, transmission of the largest 1 byte variable value.
Nominal voltage: AC 230 V, 50-60 Hz
Outputs: 6, electronic
Nominal current: 0.05 A, ohmic
Starting current: max. 1.5 A
Minimum load per used output: 1 valve drive
Number of valve drives max. 4 per output
Device width: 4 modules = approx. 72 mm
Contents: With bus connecting terminal and cable cover.
