> PremisesDistribution > Patch Panels & Block > K110N50PCC,110 Kit,50-Pair Base and 10xC4+2xC5 Connector,without Legs 
110 Connector System
The 110 Wiring Block is an extremely popular way of terminating cables for cross connecting data and voice. It is used in either a rack or wall mounted situation. The base block is where the riser/horizontal cable is terminated and a 110 connector is then placed over the terminated pairs. This now allows access for jumper wires or 110 Patch cords to cross connect. The wall mount is available with or without legs to allow room behind the block for cable entry and to stand off from the wall.
The blocks are available in 50,100 and 300-Pair with legs. Blocks without legs are available in 50 and 100-Pair configurations. The 110 connectors are available in 4 and 5-Pair sizes. The termination of cable on 110 wiring blocks is achieved with the use of 110 tools. Use either the single contact tool or the speedy 5-Pair termination tool. Both tools have a cut-off mechanism. Both can be used on the wiring block bases (for cable termination) as well as the top of the IDC contact block (for jumpering). The 5-Pair tool can only be used to terminate on the wiring block and not to terminate jumpers on the 110 connector.
Product Features
• Popular 110 connector technology.
• Available with or without legs for the Block Base.
• Speedy 5-Pair punch down Block Base saving installation time and cost.
• Suitable for jumper wire or patch cords.
• 4 and 5-Pair 110 connectors available.
