> Lighting Control > Blind actuators > MTN649912,Blind / switch actuator REG-K/12x/24x/10 with manual mode 
For independent control of up to 12 blind/roller shutter drives or for switching up to 24 loads via make contacts. The function of the blind or switching channels is freely configurable. All blind/switch outputs can be operated manually using push-buttons. With integrated bus coupler. For installation on DIN rails EN 50022.
The bus is connected using a bus connecting terminal; a data rail is not necessary. Channel status display via LEDs. A green LED indicates readiness for operation.
KNX software functions: Blind functions: Blind type. Running time. Idle time. Step interval. Weather alarm. 8-bit positioning for height and slats. Scenes. Status and feedback function. Switch actuator functions: Operation as break contact/make contact. Programmable behaviour for download. Delay functions for each channel. Staircase lighting function with/without manual OFF function. Cut-out warning for staircase lighting function. Scenes. Central function. Disable function. Logic operation or priority control. Status feedback function for each channel.
Power supply: Nominal voltage: AC 230 V, 50 - 60 Hz
External auxiliary voltage (optional): AC 110 - 240 V, 50 - 60 Hz, max. 2 VA
For each blind output: Nominal current: 10 A, cosϕ = 0.6
Motor load: AC 230 V, max. 1000 W
For each switch output: Nominal current: 10 A, cosϕ = 1; 10 A, cosϕ = 0.6
Incandescent lamps: AC 230 V, max. 2000 W
Halogen lamps: AC 230 V, max. 1700 W
Fluorescent lamps:AC 230 V, max. 1800 W, uncompensated
AC 230 V, max. 1000 W parallel-compensated
Capacitive load: AC 230 V, max. 105 μF
Device width: 12 modules = approx. 216 mm
Note: The blind actuator/switch actuator cannot be used in conjunction with the weather-dependent automatic functions of the weather combi-sensor/DCF77 art. no. MTN663692. If you require these functions then use the blind actuators art. no. MTN6498...
Contents: With bus connecting terminal and cable cover.
Plz quote for 10 nos